|Beijer Electronics (formerly QSI Corporation)
|A12 Panel; Brightness adjustment
|Page 1 of 1|
|Author:||kkwon [ Wed Jan 16, 2013 7:26 am ]|
|Post subject:||A12 Panel; Brightness adjustment|
We are using the A12 panel running Qlarity 2.63. The brightness is adjusted via the routine
setsystemsetting(SYS_BACKLIGHT, nBacklight, SYSACT_DONOW) where nBacklight is from 0 to 255.
With the zero setting it is still too bright. Is it possible to get the panel brightness lower than the
zero backlight setting issued using setsystemsetting? Or is this a hardware limitation?
|Author:||Ron L. [ Wed Jan 16, 2013 9:46 am ]|
|Post subject:||Re: A12 Panel; Brightness adjustment|
If you have a new enough operating system on the QTERM-A12, there is a registry setting you can change. To do this:
1. Press “Alt + F4” on a USB keyboard to exist to WinCE.
2. Run the program “RegEditCE.exe” under “/harddisk/bin”.
Update the registry.
Set that to 1 and reboot should enable.
|Page 1 of 1||All times are UTC - 7 hours|
|Powered by phpBB® Forum Software © phpBB Group