Beijer Electronics (formerly QSI Corporation)

Manufacturer of Mobile Data and Human Machine Interface Terminals.
It is currently Wed Mar 21, 2018 3:24 pm

All times are UTC - 7 hours

Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Fri Aug 27, 2010 10:39 am 
User avatar

Joined: Thu Jan 14, 2010 10:20 am
Posts: 38
The most common connection path for TREQ devices is the following:

photo 1.jpg
photo 1.jpg [ 45.72 KiB | Viewed 4414 times ]

The Active-Sync settings for such a setup might look like this on the PC side. This is assuming you are using the COM1 port on the PC. Also be aware that in this setup you are not going to use the USB Connection option, make sure to uncheck it.

activesync.PNG [ 12.27 KiB | Viewed 4416 times ]

"Wait! But my new laptop does not have a serial port!". If this is the case, you will need to create a serial port on your laptop by using a SECOND usb-serial converter. This image depicts such a usage scenario:

photo 2.jpg
photo 2.jpg [ 45.61 KiB | Viewed 4416 times ]

This setup once again uses the same Active Sync settings as above. You may be asking, well then what IS the USB Connections checkbox for? Well, if you happened to have one of our WinCE G56/58 devices, then your setup scenario would look like this:

photo.jpg [ 49.55 KiB | Viewed 4415 times ]

This is the scenario where you would want to check "Allow USB Connections" instead of "Allow connections to one of the following:" "COM1" etc.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 7 hours

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group